Bosch eBike Systems
Display
410
Button on the on-board computer stuck or disabled
The system has detected that one or more buttons on the on-board computer or control unit are permanently pressed or not responding. This is usually caused by dirt or moisture that has worked its way in around the button. The drive itself is normally not damaged.
- Drive system
- Bosch eBike Systems
- Category
- Display
- Motor behavior
- assist unaffected
- DIY-friendly?
- possible
Roadside self-help
- Check whether a button is visibly stuck and press it several times to free it
- Carefully clean and dry the buttons
- Switch the system off and on again
Possible causes
- Dirt around the button high
- Moisture in the button mechanism medium
- Mechanical damage to the button low
Symptoms
- Error 410 shown on the display
- One or more buttons do not respond
- Assist level cannot be changed
Inspection / repair
- Difficulty: easy
- DIY: possible
- no dealer tool needed
- Component: on board computer
- Component: control unit buttons
Applies to
Gen2-Gen4 (BES2/BES3)
Displays: Intuvia/Purion/Kiox/Nyon